Polaris RZR XP 1000 2014 Service Manual page 261

2. Install the shaft and bearing assembly into the outer
sheave using an arbor press.
NOTE
Press only on the outer race of the bearing during
installation to prevent damaging the bearing.
3. Line up the X on the moveable sheave with the X on
the stationary sheave. Put the sheaves together.
e
4. Install the rollers onto the roller pins
on the clutch.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
5. Install the roller pin into the sheave assembly on both
sides. The flat side of the roller pin faces towards the
sheaves.
6. Install the spring pins
Install until flush with sheave surface.
7. Install the spring over the shaft.
8. Install the clutch rollers
spider. Install the washers
the rollers. The rollers should spin freely.
r
and install
9. Install the spider dampener
install the inside spider plate
PVT SYSTEM
t
to secure the roller pins.
y
onto each side of the
u i
and E-clips to secure
o
inside the spider and
a
.
5.35
5