Polaris RZR XP 1000 2014 Service Manual page 255

TORQUE
Spider Jam Nut:
250 ft-lb (339 Nm)(Apply 0.1 mL Loctite® 7088
Primer and 0.1 mL Loctite® 620™) in 90° apart to the
threads of the spider jam nut.
9. After the spider and jamb nut have been torqued,
remove the clutch assembly from the holding fixture
and inspect the alignment marks made during
disassembly.
NOTE
If the marks illustrated below are not in alignment upon
assembly, the clutch will not be in balance and the drive
clutch assembly must be replaced.
f
10. Install the limiter spacer
CAUTION
DO NOT reassemble the drive clutch without the limiter
spacer. Belt life will be greatly reduced.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
g
and the clutch spring .
11. Install the drive clutch cover
in alignment.
j
12. Install cover bolts and torque in a cross pattern
evenly to specification.
TORQUE
Drive Clutch Cover Bolts:
9 ft-lb (12 Nm)
PVT SYSTEM
h
. Be sure all marks are
5
5.29