Pioneer PRA-BD11 Service Manual page 34

1
3-4. After confirming that all the LEDs are lit, set the video and audio input to SDI on the Function menu. Press the Preview
button of the PRV-LX1 (Product -jig 1) to monitor and check that the video and audio signals are output normally.
After the confirmation, press the Preview button again to cancel Preview mode.
A
Examples of settings on the Function menu:
B
3-5. On the Function menu set the video input to SDI and audio input to AES/EBU.
Press the Preview button of the PRV-LX1 (Product -jig 1) to monitor and check that the video and audio signals are
output normally. After the confirmation, press the Preview button again to cancel Preview mode.
Examples of settings on the Function menu:
C
D
3-6. Set the power to the PRV-LX1 (Product -jig 1) to Standby then set the Power switch on the rear panel to OFF.
Remove the PRA-BD11 then close the cable-securing lid for the FFC connectors.
E
F
34
1
2
PRA-BD11
2
3
3
4
4