Pioneer PRA-BD11 Service Manual page 65

5
PRA-BD12 output board connections
• Connect the 4-pin cable (L) already connected to connector E to connector e .
Secure the 4-pin cable (L) with a cable clamp before routing it.
Note:
The FFC cable (L) will be connected to the output board (connector f ) in Step 10
the connection in this step.
PRA-BD12
output board
4-pin cable (L)
9. Mount the rear bridge removed in Step 3 on the PRV-LX1.
•
Insert the rear bridge below the arms
board. Locate the rear bridge so that tabs
(one each on the right and left side) in the bridge. Use the four screws
to secure the bridge. Install the four screws in the following order:
Notes:
•
Route the 4-pin cable connected to connector A and E underneath the rear bridge.
•
Place the arms
rear bridge.
PRA-BD11 input board
PRA-BD12 output board
5
6
e
f
F
in the PRA-BD11 input board and the PRA-BD12 output
of the PRA-BD11 input board and the PRA-BD12 output board on top of the
6
7
E
in the PRV-LX1 enter the square holes
A
E
FFC cable (L)
Rear bridge
PRA-BD11
7
8
. Do not make
FFC cable (L)
Do not make the
connection now.
Cable clamp
removed in Step 3
8
A
B
C
D
E
F
65