5
11. Use the two screws (with washers) supplied with the PRA-BD11 input board and the screw
(with washer) supplied with the PRA-BD12 output board to secure both boards to the rear
bridge.
PRA-BD11 input board
PRA-BD12 output board
12. Install the input terminal cover (or output terminal cover) on the rear panel.
•
Secure the input terminal cover (or output terminal cover) supplied with the unit to the PRV-LX1
rear panel using the black screws removed in Step 2. First tighten screw
Note:
Install the input terminal cover on the left expansion slot (as seen from the rear).
The output terminal cover is installed in the right expansion slot (as seen from the rear).
Expansion slots on the
rear of the PRV-LX1
5
6
Input terminal cover (or output terminal cover)
PRA-BD11
6
7
Rear bridge
and then screw
7
8
A
B
C
.
D
E
F
67
8