Pioneer PRA-BD11 Service Manual page 69

5
Press the FUNCTION button to close the Function Menu.
Press the PREVIEW button on the PRV-LX1 to display
the video and audio signals input in Step
monitor.
The operation check is completed when the video monitor
displays a normal picture and the sound is normal.
Note:
If the video monitor does not display a picture and there
is no sound, the input board has probably not been
properly connected to the PRV-LX1. Set the PRV-LX1
to standby, turn off the power and disconnect the power
cord (see Step 16). Then check cable connections as
described in Step 4 and Step 8.
[PRA-BD12 output board operation check]
Use a BNC cable to connect the SDI output and AES/EBU output connectors on the output board
installed in the PRV-LX1 to equipment with SDI and AES/EBU input connectors.
Start playback on the PRV-LX1 (see the section " Playing Discs" in the PRV-LX1 Operating Instructions).
The operation check is completed when the SDI and AES/EBU video and audio signals are correctly
output to the equipment connected in Step
Note:
If the video monitor does not display a picture and there is no sound, the output board has
probably not been properly connected to the PRV-LX1. Set the PRV-LX1 to standby, turn off
the power and disconnect the power cord (see Step 16). Then check cable connections
as described in Step 4, Step 8 and Step 10
Copyrighted material that includes a signal to prevent unauthorized copying will not display a picture
and produce any sound (the screen remains black and there is no sound).
16. This completes the installation procedure.
Press the STANDBY/ON button on the PRV-LX1 front panel to set it to standby mode.
When the PRV-LX1 enters the standby mode, turn of f the power switch on the rear panel and
disconnect the power cable from the AC outlet.
5
6
on a video
.
.
PRA-BD11
6
7
Select "AES/EBU" as [A Input]
on the Function Menu.
7
8
A
B
C
D
E
F
69
8