Pioneer PRA-BD11 Service Manual page 68

1
13. Attach the supplied model number label to the front panel of the PRV-LX1 and the user
registration card.
A
Attach one of the two supplied model number labels to the top left of the PRV-LX1 front panel
(see figure below).
Attach the other model number label in the model number label field on the US user registration card
(USA only).
Note:
•
Clean the area on the top of the front panel before attaching the model number label.
•
Each board is provided with its own model number label. Attach the correct model number label to
the top of the PRV-LX1 front panel above the installed board.
14. Install the top panel in the PRV-LX1.
B
•
Use the seven screws removed in
Step 1.
Note:
Check that the FFC cables and the 4-pin
cables are connected to the PRA-BD11
input board and the PRA-BD12 output
board before installing the top panel.
C
15. Operation check to verify connections
Connect a video monitor to the video out and audio out connectors on the PRV-LX1.
Connect the PRV-LX1 power plug to an AC outlet and turn on the power switch onthe rear panel.
Then press the STANDBY/ON button on the front panel to turn on the power.
[PRA-BD11 input board operation check]
Use a BNC cable to connect the SDI input and AES/ EBU input connectors on the EBU input
connectors on the input board installed in the PRV-LX1 to equipment with SDI and AES/EBU
output connectors.
D
Output SDI and AES/EBU signals from equipment connected in Step
Set the input on the PRV-LX1 to SDI and AES/EBU
•
Press the FUNCTION button on the PRV-LX1 to open the Function Menu on the video monitor.
Use the CURSOR and ENTER button to select " SDI " as [V Input] and "AES/EBU" as[A Input ].
E
F
68
1
2
.
Select "SDI" as [V Input] on the Function Menu.
2
3
Attach model
number label here
PRA-BD11
3
4
Top panel
PRV-LX1
front panel
.
4