Pioneer PRA-BD11 Service Manual page 62

1
4. Connect the FFC cable and the 4-pin cable to the PRV-LX1.
Connect the FFC and 4-pin cables supplied with the unit to the specified PRV-LX1 connectors.
A
Notes:
•
Make sure not to confuse the connector for connecting cables to the PRA-BD11 input board with that
for connecting cables to the PRA-BD12 output board (see figure below).
•
The cables supplied with the PRA-BD11 input board resembles that supplied with the PRA-BD12 so
be sure to use the correct cable.
Use of the wrong cable will not only cause the equipment to malfunction but could damage it.
•
Do not touch the FFC cable contact surfaces (see " FFC cables"). Should you touch them,wipe
them with a dry.clean cloth.
•
Connect the FFC cable with the blue reinforced side facing the front panel (shown facing the
B
reader in the figure below).
PRA-BD11 input board connections
•
Connect the 4-pin cable (M) to connector A .
•
Unlock connector B and D by raising the stopper.
• Insert the FFC cable (M) in connector B and lock by lowering the stopper . See figure and note below (*).
• Insert the FFC cable (L) in connector D and lock by lowering the stopper . See figure and note below (*).
Blue reinforced side
C
(two lines)
Unlocked
*
Make sure that one of the two lines in the
reinforcement is not visible when the connector
is locked. If both lines are still visible, disconnect
and connect the FFC cable again.
D
PRA-BD12 output board connections
•
Connect the 4-pin cable (L) to connector E .
•
Unlock connector F by raising the stopper .
•
Insert the FFC cable (L) in connector F and lock by lowering the stopper . See figure and note below (*).
Blue reinforced side
(two lines)
E
Unlocked
*
Make sure that one of the two lines in the
reinforcement is not visible when the connector
is locked. If both lines are still visible, disconnect
and connect the FFC cable again.
F
62
1
2
Locked
D
Locked
F
PRA-BD11
2
3
FFC cable (L)
FFC cable (M)
B
4-pin cable (M)
A
FFC cable (L)
4-pin cable (L)
E
3
4
4