5
7.1.10 DISASSEMBLY
Caution on static electricity:
When handling this unit, NEVER touch the terminal area of each connector or parts on the boards.
: step- 1=2=!=⁄=5=6
Note: [Remove]
[Re-assembly] : step- 6=5=⁄=!=2=1
PRA-BD11
• How to disassemble the DINB Assy
1 Remove the four screws.
2 Remove the shield case UP.
! Remove the four screws.
⁄ Remove the two washers and two nuts.
1
!
!
⁄
⁄
5 Pull the board in the direction of 5 in the figure below until the four holes (inward projections) of the case and the four
cutouts of the DINB Assy (DOOB Assy) meet.
6 Pull out the DINB Assy (DOOB Assy) in the direction of 5 by slightly inclining it in the direction 6.
• Top view
Case (projection)
Board (cutout)
• Top view
Case (projection)
Board (cutout)
5
6
Shield case UP
2
1
!
!
Holes (inward projections)
× 2
Pull.
5
6
7
PRA-BD12
• How to disassemble the DOOB Assy
1 Remove the four screws.
2 Remove the shield case UP.
! Remove the four screws.
⁄ Remove the two washers and two nuts.
1
!
⁄
⁄
DINB Assy (DOOB Assy)
Slit (Cutouts)
Holes (inward projections)
× 2
PRA-BD11
7
8
Shield case UP
2
1
!
!
!
8
A
B
C
D
E
F
59