Cable Assembling - Siemens MOBILETT Plus Installation Instructions Manual

2 - 4

Cable assembling

1. Feed the ends of the cable with pin plugs marked K21 and K22 (65 61 992) from
the left side of the MOBILETT (pos. 1 / Fig. 2). Insert them as shown in the figure
below (pos. 1 / Fig. 4
NOTICE
Fig. 4 Insertion of cables, cutting of cable tie
2. Cut and remove the upper cable tie (pos. 2 / Fig. 4).
MOBILETT Plus/ -E/ -HP
)
To facilitate further cable attachment work:
Be sure to leave enough cable so that pin plug K9a
reaches the position K9 on the main CPU board D1
(see Fig. 18)
1
SPR8-220.031.04
Rev. 04
Page 4 of 30
09.03 CS PS 24
Installation
2
M
C
B
2
Siemens AG
Medical Solutions