Siemens MOBILETT Plus Installation Instructions Manual page 34

2 - 26
9. Fasten the other cable shielding connector with a screw to the new power supply
box (pos. 1 / Fig. 35). Remember to place a washer (KB 5.1mm) between the
connector and the power supply box.
10. Fasten the cable on the power supply box with cable ties (2.5x100mm) according
to pos. 2 / Fig. 35.
11. Mount the power supply as shown in Fig. 36 using two 5 mm screws (MRX-TT
5x10mm). Don't forget to place washers (KB 5.1mm) between the screw and
power supply carrier.
MOBILETT Plus/ -E/ -HP
Fig. 35 Fastening cable to the new power supply
Fig. 36 Mount of new power supply
SPR8-220.031.04
Rev. 04
1
2
Power supply
Page 26 of 30
09.03 CS PS 24
Installation
Siemens AG
Medical Solutions