Siemens MOBILETT Plus Installation Instructions Manual page 29

Installation
12. Mount the power supply box as shown in Fig. 25 using 5 mm screws (MC6S
5x16mm) and nuts. Be sure to use washers (KB 5.1mm, included in the kit).
Fig. 25 Mount of new power supply
13. Fasten the cable to the new power supply unit (pin plugs K24 and K25) with a
cable tie (2.5x100mm) through the hole (pos. 1 / Fig. 25).
14. The cable must also be fastened with cable ties (2.5x100mm) on the power supply
unit (pos. 1 / Fig. 26).
Fig. 26 Fastening cable to new power supply
15. Fasten the other cable shielding connector with a screw to the new power supply
box (pos. 2 / Fig. 26). Remember to place a washer (KB 5.1mm) between the
connector and the power supply box.
Siemens AG
Medical Solutions
Power supply
2
SPR8-220.031.04 Page 21 of 30
Rev. 04 09.03 CS PS 24
1
1
MOBILETT Plus/ -E/ -HP
2 - 21