ABB ACS550-02 User Manual page 42

40
Rotating arrow blinking
Stationary arrow
• Upper right – shows the active reference.
Middle. Using parameter Group 34, the middle of the LCD display can be configured
to display:
• Up to three parameter values
– By default, the displays shows three parameters.
The particular parameters depend on the value of
parameter 9904
if 9904 = 1, the display shows parameters 0102
(
– Use parameters 3401, 3408, and 3415 to select the parameters (from Group
01) to display. Entering "parameter" 0100 results in no parameter displayed.
For example, if 3401 = 0100 and 3415 = 0100, then only the parameter
specified by 3408 appears in the Control Panel display.
– You can also scale each parameter in the display. For example, use
parameters 3402...3405 to scale the parameter specified by 3401. For
example, to convert motor speed to a display of conveyor speed.
• A bar graph rather than any of the parameter values.
– Enter a negative value in the units parameter
(3405, 3412, or 3418) to change the parameter
display to a bar graph.
Bottom. The bottom of the LCD display shows:
• Lower corners – show the functions currently
assigned to the two soft keys.
• Lower middle – displays the current time (if configured to show the time).
Operating the Drive
LOC/REM – The very first time the drive is powered up, it is in the remote control
(REM) mode, and is controlled from the Control Terminal Block X1.
To switch to local control (LOC) and control the drive using the control panel, press
and hold the
RUN, is displayed:
• Release the button while LOCAL CONTROL is displayed to set the panel
reference to the current external reference. The drive stops.
• Release the button when LOCAL, KEEP RUN is displayed, to copy the current
run/stop status and the reference from the user I/O.
To switch back to remote control (REM) press and hold the
REMOTE CONTROL is displayed.
Start/Stop – To start and stop the drive press the START and STOP buttons.
Start-Up
Control Panel Display
MOTOR CTRL MODE
), 0104 (
SPEED CURRENT
LOC button until first, LOCAL CONTROL, or later, LOCAL, KEEP
REM
Drive is running but not at setpoint.
Drive is stopped.
. For example,
), 0105 ( ).
TORQUE
Significance
LOC button until
REM