ABB ACS550-02 User Manual page 80

78
0305 FAULT WORD 1
Read-only copy of the Fault Word 1.
• When a fault is active, the
corresponding bit for the active fault
is set in the Fault Words.
• Each fault has a dedicated bit
allocated within Fault Words.
• See Fault Listing on page
description of the faults.
• The control panel displays the word
in hex. For example, all zeros and a 1
in Bit 0 displays as 0001. All zeros
and a 1 in BIt 15 displays as 8000.
0306 FAULT WORD 2
Read-only copy of the Fault Word 2.
• See parameter 0305.
0307 FAULT WORD 3
Read-only copy of the Fault Word 3.
• See parameter 0305.
0308 ALARM WORD 1
• When an alarm is active, the
corresponding bit for the active alarm
is set in the Alarm Words.
• Each alarm has a dedicated bit
allocated within Alarm Words.
• Bits remain set until the whole alarm
word is reset. (Reset by writing zero
to the word.)
• The control panel displays the word
in hex. For example, all zeros and a 1
in Bit 0 displays as 0001. All zeros
and a 1 in BIt 15 displays as 8000.
0309 ALARM WORD 2
See parameter 0308.
Start-Up
Bit # 0305,
FAULT WORD
0 OVERCURRENT
1 DC OVERVOLT
2 DEV OVERTEMP
3 SHORT CIRC
165 for a
4 OVERLOAD
5 DC UNDERVOLT
6 AI1 LOSS
7 AI2 LOSS
8 MOT OVERTEMP
9 PANEL LOSS
10 ID RUN FAIL
11 MOTOR STALL
12 Reserved
13 EXT FLT 1
14 EXT FLT 2
15 EARTH FAULT
Bit # 0308,
0 Reserved
1
2
3 DIR LOCK
4 I/O COMM
5 AI1 LOSS
6 AI2 LOSS
7 PANEL LOSS
8 Reserved
9 MOT OVERTEMP
10 UNDERLOAD
11 MOTOR STALL
12 AUTORESET
13 AUTOCHANGE
14 PFC INTERLOCK
15 reserved BP LOSS
* Applies only to HVAC drives.
1 0306,
FAULT WORD
UNDERLOAD
THERM FAIL
OPEX LINK
OPEX PWR
CURR MEAS
SUPPLY PHASE
Reserved
OVERSPEED
DC HIGH RUSH
DRIVE ID
CONFIG FILE
SERIAL 1 ERR
EFB CON FILE
FORCE TRIP
MOTOR PHASE
OUTPUT WIRING
1 0309,
ALARM WORD
Reserved / OFFBUTTON 0*
PID SLEEP
ID RUN
Reserved
2 0307, 3
FAULT WORD
EFB 1
EFB 2
EFB 3
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
System Error
System Error
System Error
Hardware Error
Param. Setting Fault
2
ALARM WORD