ABB ACS550-02 User Manual page 48

46
Basic Control Panel
Features
The Basic Control Panel features:
• Numeric control panel with a LCD display.
• Drive connection that can be made or detached at any time
• Copy function – Parameters can be copied to the Control Panel memory for later
transfer to other drives, or for backup of a particular system.
Controls/Display Overview
The following table summarizes the button functions and displays on the Basic
Control Panel.
EXIT/RESET key – Exits to next
higher menu level. Does not save
changed values.
Up –
• Scrolls up through a menu or list.
• Increases a value if a parameter is
selected.
• Decreases the reference when in
the reference mode of operation.
LOC/REM – Changes between local
and remote control of the drive.
Output Mode
Use the Output mode to read information on the drive's status and to operate the
drive. To reach the Output mode, press EXIT/RESET until the display shows status
information as described below.
Start-Up
LCD DISPLAY – Divided into five areas:
• Upper left – Identifies control location, local (LOC) or remote (REM).
• Upper right – Identifies parameter units.
• Center – Variable, in general, shows parameter values, menus or lists.
Also displays a code for control panel errors (See.
• Lower left – "OUTPUT" in the control mode, or "MENU" when selecting
alternate modes.
• Lower right – Motor rotation direction, and indicates when a value can be
edited ( SET ).
REM
OUTPUT
EXIT/
RESET
STOP – Stops the drive.
MENU/ENTER key – Enters deeper
into menu level. At deepest menu
level, saves display value as new
A
setting.
1.1
Down –
FWD
• Scrolls down through a menu or
list.
MENU/
ENTER
• Increases a value if a parameter is
selected.
• Decreases the reference when in
the reference mode of operation.
DIR key – Changes the motor's
direction of rotation.
START – Starts the drive.
FM