Materials; Applicable Standards - ABB ACS550-02 User Manual

186

Materials

Drive enclosure
Package
Disposal

Applicable Standards

The drive complies with the following standards. The compliance with the European
Low Voltage Directive is verified according to standards EN 50178 and EN 60204-1.
EN 50178 (1997)
EN 60204-1 (1997)
EN 60529: 1991 (IEC 529),
IEC 60664-1 (1992)
EN 61800-3 (1996) +
Amendment A11 (2000)
UL 508C
CE / UL Markings / C-Tick
UL Markings status:
R7...R8
UL
The ACS550 is suitable for use on a circuit capable of delivering not more than
65,000 RMS symmetrical amperes, 480 V maximum. The ACS550 has an electronic
motor protection feature that complies with the requirements of UL 508C. When this
feature is selected and properly adjusted, additional overload protection is not
Technical Data
• PC/ABS 2.5 mm, color NCS 1502-Y (RAL 9002 / PMS 420 C and 425 C)
• Hot-dip zinc coated steel sheet 1.5...2 mm, thickness of coating 100
micrometers
Plywood box with expanded polystyrene pillows. Plastic covering of the
package: PE-LD, bands PP or steel.
The drive contains raw materials that should be recycled to preserve energy
and natural resources. The package materials are environmentally compatible
and recyclable. All metal parts can be recycled. The plastic parts can either be
recycled or burned under controlled circumstances, according to local
regulations. Most recyclable parts are marked with recycling marks.
If recycling is not feasible, all parts excluding electrolytic capacitors and printed
circuit boards can be landfilled. The DC capacitors contain electrolyte and the
printed circuit boards contain lead, both of which will be classified as hazardous
waste within the EU. They must be removed and handled according to local
regulations.
For further information on environmental aspects and more detailed recycling
instructions, please contact your local ABB distributor.
Electronic equipment for use in power installations
Safety of machinery. Electrical equipment of machines. Part 1:
General requirements. Provisions for compliance: The final assembler
of the machine is responsible for installing:
• An emergency-stop device
• A supply disconnecting device
Degrees of protection provided by enclosures (IP code)
EMC product standard including specific test methods
UL Standard for Safety, Power Conversion Equipment, second edition
ACS550 CE
Approved
Materials Specifications
Applicable Standards
UL C-UL
Approved Approved
C-Tick
Pending