Mitsubishi Electric MELSEC iQ-R Series User Manual page 114

of a camera recorder module. (Page 282 Network camera status area (Un\G34000 to 37999))
*2 For access, a personal computer and network camera must be connected via Ethernet.
*3 When selecting and double-clicking a row, the "Preset Position Registration" screen opens with the number of the selected row selected.
Page 113 Preset position registration
*4 The [Execute] button can be clicked only when selecting "PTZ Enable Mode" or "PTZ Preset Mode" for "PTZ Control Authority Mode" of
a target network camera.
*5 To check the status, click the [Camera Access] button to access the network camera in advance.
*6 Can be clicked only when selecting "PTZ Enable Mode" for "PTZ Control Authority Mode" of a target network camera.
Registering or deleting a preset position, or moving to a preset position is performed in the communication
route set in the "Specify Connection Destination" screen of GX Works3.
Precautions
• The range that can be set differs for the manufacturer and type of each network camera. If a position registered as a preset
position exceeds the range for a network camera when replacing it, moving to the preset position is not guaranteed.
In addition, preset position information is not initialized when replacing a network camera.
• When moving the range of captured data to a preset position in this screen and in a dedicated tool for the network camera
at the same time, it is moved in order of request.
• If this screen is opened before the communication between a network camera and a camera recorder module is completed,
the manufacturer name and model name may not be displayed in the camera information when starting the system. To
display them, wait a few minutes until the communication is completed, and then open this screen again.
Note that the manufacturer name and model name are always blank if a network camera is not connected.
2 PARAMETER SETTING
112
2.4 Preset Position Setting (Camera Recorder Module)