Mitsubishi Electric MELSEC iQ-R Series User Manual page 192

Error code Error name
1D01H Network Camera Undetected
Error
1D10H Parameter Inconsistency Error
1D11H Parameter Inconsistency Error
1D30H Network Camera Account
Authentication Error
1D40H Network Camera Video
Maximum Bit Rate Limit
Unsupported Error
1D41H Camera Event Type
Unsupported Error
1D50H Network Camera Video Setting
Error
1D51H Network Camera Video Setting
Error
1D52H Network Camera Video Setting
Error
1D53H Network Camera Video Setting
Error
1D54H Camera Event Setting
Inconsistency Error
1D80H Network Camera Video Rotation
Angle Unsupported Error
5 TROUBLESHOOTING
190
5.7 Camera Recorder Module
Error description
The target network camera cannot be found.
The number of network cameras that receive
video data is inconsistent between the
module extension parameter and the
recording setting.
The number of network cameras that receive
video data is inconsistent between the
recording operation setting of the module
parameter and the recording setting.
Failed to authenticate the target network
camera.
The target network camera does not support
the function which limits the maximum video
bit rate.
The target network camera does not support
the set camera event type.
The resolution of the target network camera
is incorrect.
The frame rate setting of the target network
camera is incorrect.
The combination of the resolution and frame
rate of the target network camera is
incorrect.
The number of connected network cameras
exceeds the upper limit.
The combination of the camera event
settings is inconsistent.
The specified target network camera does
not support the video rotation function.
Corrective action
• Please check the operation status of the other
device.
• Please check if the set camera type, IP address, and
TCP port number are correct.
• Please change the IP addresses of the network
camera and this product to the same segment.
• If a LAN of different segments is communicated via a
gateway, please consult the network administrator of
the connected LAN.
• Please change the IP address of the module to the
same segment as the network camera to be
connected. (Please do not select automatic
acquisition.)
• Please check that the following values are set in the
network camera setting when using ONVIF
supported network camera.
- Video codec: H.264
- Connection method: HTTP protocol
Please exclude the network camera(s) that is(are)
disabled in the module extension parameter from the
receiving targets in the recording setting.
Please set the number of network cameras that receive
video data to two or less in the camera recorder module
set to "Main" in the module parameter.
• Please review the account information (user ID, use
password).
• Please check the account information (use ID, use
password) set for the network camera.
• An account for ONVIF communication exists in some
network cameras. If the account exists, please check
the account information for ONVIF communication of
the network camera. For details, please refer to the
manual of the network camera to be used.
• Please review the resolution, frame rate, video
quality, and codec to reduce the bit rate.
• Please review the camera event notification setting.
• Please enable the event detection function of the
network camera. For details, please refer to the
manual of the network camera to be used.
• Immediately after starting the network camera, it may
take some time for the event detection function to be
enabled, so make sure that the network camera is
started in advance.
Please set the resolution that can be set for the network
camera.
Please set the frame rate that can be set for the
network camera.
Please review the combination of the resolution and
frame rate that can be set for the network camera.
Please review the number of network cameras
connected to the module and the setting value of the
network camera.
Please enable the camera event notification setting or
disable the camera event trigger settings.
• Please clear the setting of the video rotation angle
with the engineering tool. After changing the setting,
please write the network camera setting again with
the engineering tool.
• Please enable the simple setting mode of the module
extension parameter with the engineering tool, then
execute writing.