Application - 1-Button Blind - ABB tacteo KNX Product Manual

11.5.4

Application - 1-button blind

The application makes it possible to control blinds and roller blinds via a button.
The following communication objects are available:
"Sx: moving" (for blinds/roller blinds, 1 Bit)
■
"Sx: adjusting" (for blinds, 1-bit)
■
"Sx: position" (for blinds, 1-byte)
■
"Sx: slats" (for blinds, 1-byte)
■
"Sx: stop" (for roller blinds, 1 bit)
■
The application can be used to set the length of the button actuations for the operating functions
of blinds and roller blinds.
Blinds: Movement and slat adjustment commands are sent to linked blind actuators with long
and short button operations. A long press of the button triggers a move command. A short press
of the button triggers a command to adjust the slats.
Roller blinds: Movement and stop commands are sent to linked roller blind actuators with long
and short button operations. A long press of the button triggers a move command. A short press
of the button triggers a stop command.
Blinds and roller blinds: The sensor stores the last command carried out with the button that
is occupied with the application. This means, for example, if a blind was lowered and halted at
half height via a short press of the button, then a renewed long press of the button will raise the
blind.
In each case, the application makes a separate set of parameters and communication objects
available in function block x for both buttons.
Note
The parameters for application "1-button blind" can be called up via general
parameters and extended parameters.
Note
The number (S1 - Sx) of the object depends on the function block and the button
number.
Product manual 2CKA001473B9488
Description of application and parameters
Application "Function block x"
│68