Figure 56. Removing the riser 3 assembly
After you finish
1. Remove the PCIe adapter from the riser assembly. See
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Remove a PCIe adapter
Follow instructions in this section to remove a PCIe adapter.
About this task
Attention:
• Read
"Installation Guidelines" on page 39
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Watch the procedure
A video of this procedure is available at YouTube:
DR4X1YAcp9wFKhwj_tLQ5Y
and
"Safety inspection checklist" on page 40
48.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Remove a PCIe adapter" on page
.
Chapter 5
Hardware replacement procedures
99.
to ensure that you
99