Memory Module Replacement; Remove A Memory Module - Lenovo ThinkSystem SR665 V3 User Manual

Complete the parts replacement. See

Memory module replacement

Follow instructions in this section to remove and install a memory module.
• "Remove a memory module" on page 90
• "Install a memory module" on page 91

Remove a memory module

Follow instructions in this section to remove a memory module.
About this task
Attention:
• Read "Installation Guidelines" on page 39
work safely.
• Memory modules are sensitive to static discharge and require special handling. Refer to the standard
guidelines for "Handling static-sensitive devices" on page
– Always wear an electrostatic-discharge strap when removing or installing memory modules.
Electrostatic-discharge gloves can also be used.
– Never hold two or more memory modules together so that they do not touch each other. Do not stack
memory modules directly on top of each other during storage.
– Never touch the gold memory module connector contacts or allow these contacts to touch the outside
of the memory module connector housing.
– Handle memory modules with care: never bend, twist, or drop a memory module.
– Do not use any metal tools (such as jigs or clamps) to handle the memory modules, because the rigid
metals may damage the memory modules.
– Do not insert memory modules while holding packages or passive components, which can cause
package cracks or detachment of passive components by the high insertion force.
• In the case of processor board replacement, keep records of the slots in which the modules are installed,
and make sure to install them back to the exact same slots after processor board replacement.
• If you are not installing a replacement memory module to the same slot, make sure you have memory
module filler available.
Watch the procedure
A video of this procedure is available at YouTube:
DR4X1YAcp9wFKhwj_tLQ5Y
Procedure
Step 1. Make preparation for the task.
a. Power off the server and peripheral devices and disconnect the power cords and all external
cables. See
b. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
c. Remove the top cover. See
d. Remove the air baffle. See
ThinkSystem SR665 V3 User Guide
90
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 40
.
"Power off the server" on page
"Remove the top cover" on page
"Remove the air baffle" on page
42.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
48.
"Remove the server from rack" on page
161.
57.
164.
to ensure that you
49.