Lenovo ThinkSystem SR665 V3 User Manual page 161

• Read "Installation Guidelines" on page 39
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Put electrostatic-discharge gloves on before handling extremely sensitive electronic boards.
• After replacing the system I/O board or processor board, always update the server with the latest firmware
or restore the pre-existing firmware.
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/tw/en/products/servers/thinksystem/sr665v3/7d9a/downloads/
to see the latest firmware and driver updates for your server.
driver-list/
• Go to "Update the firmware" on page 189
Watch the procedure
A video of this procedure is available at YouTube:
DR4X1YAcp9wFKhwj_tLQ5Y
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Depending on your need, do one of the following:
• If you are going to replace the system I/O board and reuse the processor board, install a new
system I/O board onto the processor board.
• If you are going to replace the processor board and reuse the system I/O board, install the
existing system I/O board onto a new processor board.
and "Safety inspection checklist" on page 40
48.
for more information on firmware updating tools.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
.
Chapter 5 Hardware replacement procedures
to ensure that you
151