Install A Rearwall Bracket - Lenovo ThinkSystem SR665 V3 User Manual

Figure 92. Removing the C1 rearwall bracket (right)
After you finish
1. Install required rearwall brackets back to the rear chassis.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.

Install a rearwall bracket

Follow instructions in this section to install a rearwall bracket.
About this task
Attention:
• Read "Installation Guidelines" on page 39
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
DR4X1YAcp9wFKhwj_tLQ5Y
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Install the rearwall brackets.
a. Align the rearwall bracket with the chassis, and insert the bracket into place.
b. Install the screws to secure the rearwall bracket.
ThinkSystem SR665 V3 User Guide
132
and "Safety inspection checklist" on page 40
48.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
to ensure that you