Lenovo ThinkSystem SR665 V3 User Manual page 138

• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Watch the procedure
A video of this procedure is available at YouTube:
DR4X1YAcp9wFKhwj_tLQ5Y
Procedure
Step 1. Make preparation for the task.
a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
b. Remove the top cover. See
c. Disconnect the cable of the RAID flash power module.
Step 2. Remove the RAID flash power module from the air baffle.
Figure 88. Removing the RAID flash power module from the air baffle
a. Open the retention clip on the holder of the RAID flash power module.
b. Take the RAID flash power module out of the holder.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a RAID flash power module on the air baffle
Follow instructions in this section to install a RAID flash power module (also called supercap) on the air baffle.
About this task
Attention:
ThinkSystem SR665 V3 User Guide
128
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Remove the top cover" on page
"Remove the server from rack" on page
161.
49.