Rearwall Bracket Replacement - Lenovo ThinkSystem SR665 V3 User Manual

• Read "Installation Guidelines" on page 39
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
DR4X1YAcp9wFKhwj_tLQ5Y
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Install the RAID flash power module on the air baffle.
Figure 89. Installing the RAID flash power module on the air baffle
a. Open the retention clip on the holder.
b. Put the RAID flash power module into the holder.
c. Press it down to secure it into the holder.
Step 3. Connect the RAID flash power module to an adapter with the extension cable that comes with the
RAID flash power module. See
After you finish
Complete the parts replacement. See

Rearwall bracket replacement

Follow instructions in this section to remove and install a rearwall bracket.
The rearwall brackets vary by server rear configurations.
• "Remove a rearwall bracket" on page 130
and "Safety inspection checklist" on page 40
48.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
Chapter 6 "Internal cable routing" on page
"Complete the parts replacement" on page
167.
164.
.
Chapter 5 Hardware replacement procedures
to ensure that you
129