Memory Module Replacement; Remove A Memory Module - Lenovo ThinkSystem SR630 Maintenance Manual

Step 1. Touch the static-protective package that contains the intrusion switch to any unpainted surface on
the outside of the server. Then, take the intrusion switch out of the package and place them on a
static-protective surface.
Step 2. Insert the intrusion switch and push it in the direction as shown until it is fully seated.
Figure 85. Intrusion switch installation
Step 3. Connect the cable of the intrusion switch to the intrusion switch connector on the system board.
See "Intrusion switch" on page 59.
After you finish
Complete the parts replacement. See "Complete the parts replacement" on page 224.

Memory module replacement

Use this information to remove and install a memory module.

Remove a memory module

Use this information to remove a memory module.
About this task
Attention:
• Read "Installation guidelines" on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Memory modules are sensitive to static discharge and require special handling. Refer to the standard
guidelines for "Handling static-sensitive devices" on page 85.
– Always wear an electrostatic-discharge strap when removing or installing memory modules.
Electrostatic-discharge gloves can also be used.
– Never hold two or more memory modules together so that they touch. Do not stack memory modules
directly on top of each other during storage.
– Never touch the gold memory module connector contacts or allow these contacts to touch the outside
of the memory module connector housing.
– Handle memory modules with care: never bend, twist, or drop a memory module.
ThinkSystem SR630 V2 Maintenance Manual
148