Lenovo ThinkSystem SR630 Maintenance Manual page 77

Cable routing for onboard configuration
The following table shows the mapping relationship between backplane connectors and system board
connectors for onboard configuration.
Table 22. Mapping between backplane connectors and system board connectors for onboard configuration
Backplanes
Front BP (NVMe)
Front BP (SAS)
Rear BP (if any)
Note: *NVMe 0-1 and NVMe 2-3 connectors are available only when the 4 x 3.5'' AnyBay front backplane is
used.
The following figure illustrates the cable routing for the onboard configuration of 4 x 3.5-inch front AnyBay
drive bays with a rear 2 x 2.5-inch NVMe drive cage. Connections between connectors:
↔
, ...
3 n n
Figure 21. Cable routing for onboard configuration of 4 x 3.5-inch front AnyBay drive bays with a rear 2 x 2.5-inch NVMe
drive cage
From
NVMe 0-1*, 2-3*
SAS
SAS
NVMe 0, NVMe 1
To
PCIe 1, PCIe 2
SATA 0
SATA 2
PCIe 6
↔
,
1 1 2
.
Chapter 3 Internal cable routing
↔ ↔
,
2 3
67