Lenovo ThinkSystem SR630 Maintenance Manual page 108

• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
Step 1. Touch the static-protective package that contains the backplane to any unpainted surface on the
outside of the server. Then, take the backplane out of the package and place it on a static-
protective surface.
Step 2. Connect the cables to the backplane. See "2.5-inch/3.5-inch drive backplane (power)" on page 65
and "2.5-inch/3.5-inch drive backplane (signal)" on page 66.
Step 3. Put the backplane down into place.
Figure 39. Installation of backplane for four 3.5-inch hot-swap drives
a. Put the backplane under the front I/O assembly cables, align it with the chassis, and lower it
into the chassis. Put the backplane into place with it leaning backward slightly so that the three
pins on the chassis pass through the three holes
1
b. Close the release latches to secure the backplane in place.
ThinkSystem SR630 V2 Maintenance Manual
98
in the backplane.
2