Lenovo ThinkSystem SR630 Maintenance Manual page 15

Table 1. Server specifications (continued)
Specification
Internal drives
Expansion slots
Graphics processing unit
(GPU)
Description
Front:
• Up to four 3.5-inch hot-swap SAS/SATA drives
• Up to four 3.5-inch hot-swap AnyBay (SAS/SATA/NVMe) drives
• Up to four 2.5-inch hot-swap SAS/SATA drives
• Up to eight 2.5-inch hot-swap SAS/SATA/U.3 NVMe drives
• Up to six 2.5-inch hot-swap SAS/SATA and four 2.5-inch hot-swap AnyBay (SAS/
SATA/NVMe) drives
• Up to six 2.5-inch hot-swap SAS/SATA and four 2.5-inch hot-swap NVMe drives
• Up to six 2.5-inch hot-swap SAS/SATA and two 2.5-inch hot-swap AnyBay (SAS/
SATA/NVMe) drives and two 2.5-inch hot-swap NVMe drives
• Up to ten 2.5-inch hot-swap NVMe drives
• Up to ten 2.5-inch hot-swap AnyBay (SAS/SATA/NVMe) drives
• Up to 16 hot-swap EDSFF drives
Inside:
• Up to two internal SATA or NVMe M.2 drives
Rear:
• Up to two 2.5-inch hot-swap SAS/SATA or NVMe drives
• Up to two 7mm hot-swap SATA or NVMe drives
Notes:
• M.2 and 7mm drives are not supported at the same time.
• If PMEM or 256 GB DIMM is used, rear 2.5-inch drives are not supported.
• For the server model with 16 front EDSFF drives, M.2 drives are not supported.
• For technical rules for drives, see "Technical rules for drives" on page 87.
Depending on the model, your server supports up to three PCIe slots in the rear.
• PCIe x16, low-profile
• PCIe x16/x16, low-profile + low profile
• PCIe x16/x16, low profile + full-height
For locations and technical rules for PCIe slots, see "Rear view" on page 39 and
"Technical rules for PCIe adapters" on page 88.
Your server supports the following GPUs:
• Low-profile, half-length, single-wide: NVIDIA
only), NVIDIA ® Quadro ®
• Full-height, 3/4 length, single-wide: NVIDIA
For technical rules for GPU, see "Technical rules for GPU adapters" on page 89.
® Tesla T4 16GB Base Card (for China
P620, NVIDIA ® Tesla ® T4
® Quadro ® P2200
.
Chapter 1 Introduction
5