Complete The Parts Replacement - Lenovo ThinkSystem SR630 Maintenance Manual

Step 2. Install the top cover to your server.
Attention: Handle the top cover carefully. Dropping the top cover with the cover latch open might
damage the cover latch.
Figure 145. Top cover installation
a. Ensure that the cover latch is in the open position. Lower the top cover onto the chassis until
both sides of the top cover engage the guides on both sides of the chassis. Then, slide the top
cover to the front of the chassis.
Note: Before you slide the top cover forward, ensure that all the tabs on the top cover engage
the chassis correctly.
b. Press down the cover latch and ensure that the cover latch is completely closed.
c. Use a screwdriver to turn the cover lock to the locked position.
After you finish
After installing the top cover, complete the parts replacement. See "Complete the parts replacement" on
page 224.

Complete the parts replacement

Use this information to complete the parts replacement.
To complete the parts replacement, do the following:
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your server.
2. Properly route and secure the cables in the server. Refer to detailed cable routing information for each
component inChapter 3 "Internal cable routing" on page 55.
3. If you have removed the top cover, reinstall it. See "Install the top cover" on page 222.
ThinkSystem SR630 V2 Maintenance Manual
224