Hot-Swap Drive Replacement - Lenovo ThinkSystem SR630 Maintenance Manual

Note: The heat sink, processor, and processor carrier for your system might be different from those shown
in the illustrations.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
Step 1. Install the Torx T30 nut.
Figure 63. Installing a Torx T30 nut into the heat sink
Note: Do not touch the gold contacts on the bottom of the processor.
a. Rotate the anti-tilt wire bail inwards.
b. Orient the Torx T30 nut under the anti-tilt wire bail; then, align the Torx T30 nut with the socket
at an angle as shown.
c. Push the lower edge of the Torx T30 nut into the socket until it clicks into place. Make sure the
Torx T30 nut is secured under the four clips in the socket.
After you finish
1. Reinstall the PHM. See "Install a processor and heat sink" on page 181.
2. Complete the parts replacement. See "Complete the parts replacement" on page 224.

Hot-swap drive replacement

Use this information to remove and install a hot-swap drive. You can remove or install a hot-swap drive
without turning off the server, which helps you avoid significant interruption to the operation of the system.
Notes:
.
Chapter 4 Hardware replacement procedures
123