Lenovo ThinkSystem SR630 Maintenance Manual page 27

To place the server in a standby state (power status LED flashes once per second):
Note: The Lenovo XClarity Controller can place the server in a standby state as an automatic response to a
critical system failure.
• Start an orderly shutdown using the operating system (if supported by your operating system).
• Press the power button to start an orderly shutdown (if supported by your operating system).
• Press and hold the power button for more than 4 seconds to force a shutdown.
• Send remote power-off commands to Lenovo XClarity Controller via Lenovo XClarity Essentials OneCLI,
IPMItool, or SSH CLI.
When in a standby state, the server can respond to remote power-on requests sent to the Lenovo XClarity
Controller. For information about powering on the server, see "Power on the server" on page 16.
.
Chapter 1 Introduction
17