Install The Front I/O Assembly - Lenovo ThinkSystem SR630 Maintenance Manual

Install the front I/O assembly

Use this information to install the front I/O assembly.
About this task
The following illustrates how to install the front I/O assembly with diagnostics panel. You can install other
front I/O assemblies in the same way.
Attention:
• Read "Installation guidelines" on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
Step 1. Touch the static-protective package that contains the front I/O assembly to any unpainted surface
on the outside of the server. Then, take the front I/O assembly out of the package and place it on a
static-protective surface.
Step 2. Install the front I/O assembly.
Figure 56. Installation of the front I/O assembly
a. Insert the front I/O assembly into the front chassis.
b. Install the screws to secure the front I/O assembly in place.
After you finish
1. Connect the front I/O cables to the system board. See "Front I/O" on page 58.
2. Complete the parts replacement. See "Complete the parts replacement" on page 224.
.
Chapter 4 Hardware replacement procedures
117