Processor And Heat Sink Replacement; Remove A Processor And Heat Sink - Lenovo ThinkSystem SR630 Maintenance Manual

Step 3. Install the PCIe adapter and secure it to the riser assembly.
Figure 99. PCIe adapter installation into the LP-FH riser assembly
a. Align the PCIe adapter with the PCIe slot on the riser card. Then, carefully press the PCIe
adapter straight into the slot until it is securely seated and its bracket also is secured.
b. Rotate the latch on the riser bracket to the closed position.
Notes:
1. Ensure that PCIe adapter installation meets "Technical rules for PCIe adapters" on page 88.
2. The procedure for installing a PCIe adapter is similar for different types of riser assembly. In
this topic, the LP-FH riser assembly is used as an example.
Step 4. Connect cables to the PCIe adapter in the riser assembly. See Chapter 3 "Internal cable routing" on
page 55.
After you finish
1. Reinstall the riser assembly. See "Install a riser card" on page 201.
2. Complete the parts replacement. See "Complete the parts replacement" on page 224.

Processor and heat sink replacement

Use this information to remove and install a processor and heat sink.
Attention: Before you begin replacing a processor, make sure that you have an alcohol cleaning pad (part
number 00MP352) and thermal grease.

Remove a processor and heat sink

This task has instructions for removing an assembled processor and heat sink, known as a processor-heat-
sink module (PHM). This task requires a Torx T30 driver. This procedure must be executed by a trained
technician.
About this task
S002
ThinkSystem SR630 V2 Maintenance Manual
176