Huawei FusionModule1000A20 Commissioning Manual page 100

FusionModule1000A20 Prefabricated All-in-One
Data Center
Commissioning Guide
●
Step 4 Log in to the NetEco WebUI as an administrator.
Step 5 Choose Configuration > Configuration Management > Data Center Planning.
The Data Center Planning window is displayed.
Step 6 Select the management domain to add a device. The management domain can be
a modular, rack, or equipment room.
Step 7 (Optional) If the management domain is a rack, click the management domain
and choose Design under
Otherwise, skip this step.
Step 8 In the lower-left corner of the page, click the Device tab.
Step 9 Click the drop-down list box in Type and select Sensor.
Step 10 In this example, a Polymer temperature and humidity (T/H) sensor is added in the
equipment room of the root node. Select the device to be added and drag its icon
to the management domain.
Step 11 Click the device. In the device parameter area on the right, set device parameters
according to the following table.
Step 12 Click
Step 13 Choose System > Configuration Management > Transmission Channel
Management.
Step 14 Click Modify after selecting the IP address of the ECC800 connected to the NMS.
●
●
Issue 03 (2022-12-15)
If the port has been used, you will be prompted that the transparent
transmission function cannot be enabled and you need to select an idle port.
NO TE
IP Address indicates the ECC800 login IP address. Port indicates the ECC800 COM2 port
(3212). Device Address indicates the Polymer T/H sensor address.
to save the created device view.
If Connection mode is set to Compatible, click Confirm.
NO TE
On the ECC800 WebUI, Enable Security Authentication is set to Disable.
If Connection mode is set to Security protocol, enter the value of Confirm
password that has been set on the ECC800 WebUI, and click Confirm.
Copyright © Huawei Digital Power Technologies Co., Ltd.
9 Commissioning Core Components
. The page for adding a device is displayed.
93