ABB IRC5 Startup Manual page 19

ABB IRC5/IRC5C Startup Guide (PROGRAM Mode) | 9 - Configuring the ABB Controller in RobotStudio | 19
3. Use an Ethernet caule to connect yoHr RouotOtHdio compHter to the ABB controller service port: X2 (Service).
4. ‍n yoHr RouotOtHdio compHter, configHre the IP settings to connect with the ABB controller.
Note:
The uelow sHusteps assHme that yoHr RouotOtHdio compHter is a Windows compHter. If yoH are not Hsing
a Windows compHter, follow yoHr compHter's procedHre for configHring IP settings.
a. ‍pen the RHn uox uy pressing Windows key + R on the keyuoard or right-click the Otart MenH uHtton and
select Run.
u. In the RHn pop-Hp, type "ncpa.cpl" (Network Connections panel) and click OK.
c. ‍n the Network Connections window, doHule-click the Ethernet connection yoH are Hsing on the compHter.
For compHters with one Ethernet port, it's the Ethernet option.