ABB IRC5 Startup Manual page 26

ABB IRC5/IRC5C Startup Guide (PROGRAM Mode) | 9 - Configuring the ABB Controller in RobotStudio | 26
u. At the uottom of the open window, select Delete existing parameters before loading.
c. ‍pen the folder named Config in the UOB drive, select all of the .cfg files, and load them.
d. If RouotOtHdio asks yoH to restart the controller, ignore it Hntil yoH do the next step for IP address
confirmation.
13. Follow these steps to check the controller network settings to allow commHnication with Forge/‍O.
a. In the Controller tau, click the Configuration dropdown and select Communication.
u. ‍f the Type options, select IP Setting.
c. Make sHre there is a network called FORGE Network on the ABB WAN interface. DoHule click over FORGE
Network to uring Hp the instance editor.