Dell EMC PowerEdge MX7000 Field Service Manual page 50

Installing a MX7000 blank in Fabric C slot
Prerequisites
1. Remove the module from Fabric C
Steps
1. Align and insert the blank in the empty slot.
2. Push the blank until it locks into place.
Figure 56. Installing a blank in Fabric C slot
Removing a MX7000 module from Fabric C slot
Prerequisites
1. Disconnect the cables that are connected to the modules.
Steps
1. Press the orange release button on the module to open the release lever.
2. Hold the release lever, and pull the I/O module out of the enclosure.
NOTE: Ensure that you install MX7000 an IOM blank if you are removing a module permanently.
50 Field service information
slot.