Huawei FusionDC1000A Product Description page 94

FusionDC1000A Prefabricated All-in-One Data
Center
Product Description (IT Scenario)
(4) RS485 port COM1
(7) BLINK button
(10) AI/DI_2 dry contact
(reserved port for linkage
control or third-party fire
extinguishing system dry
contacts)
Specifications
Table 6-26 Access actuator technical specifications
Item
Power input
PoE port
Wireless
communicat
ion
AI/DI port
DO/DI port
RS485 serial
port
expansion
Wiegand
port
BLINK
button
Address DIP
switch
E-label
Issue 04 (2023-11-10)
(5) Address DIP switch
(8) WG_2 Wiegand interface (9) WG_1 Wiegand interface
(11) AI/DI_1 dry contact
(reserved port for exit
button)
Specifications
● DC input: terminal, with an input voltage of 36 V DC–60 V DC
● PoE power supply: one PoE port that complies with
IEEE802.3at
FE communication with the rate of 10/100 Mbit/s
One wireless communication port that complies with IEEE
802.15.4, mutual backup with FE communication
Two AI/DI ports, can connect to the fire alarm and exit button
● One 12 V DC power output that controls magnetic locks,
terminal
● One DI input port for connecting to the door status switch
Two RS485 ports (one route) with the default communication
rate of 9600 bit/s, physical port cascading supported (reserved
function)
Two Wiegand ports, 12 V DC card reader operating power output;
two routes of card readers can operate at the same time.
● Press the button for less than 1 second to start blinking.
● Hold down the button for 1–5 seconds to search for a network
and start networking.
● Hold down the button for more than 10 seconds to clear
network parameters.
4-pin address DIP switch
Supported
Copyright © Huawei Digital Power Technologies Co., Ltd.
6 Management System
(6) Status indicator
(12) LOCK/GND/GATE/COM door
status sensor and magnetic lock
port
87