23.2.7 Detergent/steam vent and fill pipe
Remove the worktop (see relevant paragraph).
Remove the control panel.
Remove the detergent dispenser (see relevant paragraph).
Remove the sleeve from the tub.
When re-assembling the pipe to the dispenser apply a sealant like Bostik
and make sure the reference points found on the dispenser and sleeve,
correspond.
23.2.8 Top counterweight
Remove the worktop (see relevant paragraph).
Remove the three screws that secure it to the welded tub.
Re-assembly: tighten the screws at a torque of 25÷28 N.
23.3 Accessing the front part
1. Bellow seal
2. Door hinge
3. Door
4. Door safety interlock
23.3.1 Bellow seal
Remove the iron ring securing the bellow seal to the cabinet.
Remove the bellow seal from the welded tub.
(take care as the seal is held in position by a snap ring).
Remove the small outlet pipe located in the lower part of the outlet
(fitted to the tub with Bostik that is resistant to water and high
temperatures).
When reassembling the seal.
Clean away the hardened sealant from the small outlet pipe's fixing
hole of the bellow seal, before putting on new sealant.
Use liquid soap to lubricate the part traced in red where the tub is
inserted.
103/124
Technical Support - DMM
599 75 58-67 Rev.04