Display - Electrolux EWM09311 Service Manual

•
L12 Door closed: It lights up when the safety device prevents the door from
opening and switches off when it can be opened. It flashes when the device is
about to unlock the door (it should be noted with PTC delaying devices, which
need one or two minutes to open).
•
Button no. 7: this button is configurable and has the DELAYED START
function. During the programme selection phase, a delayed start can be
selected, from 30' to 20 hours (30'
and the time is shown on the Display. During the last hour, the time
decreases minute by minute.

13.3.4 Display

The display shows the following information.
 - Duration of the washing programme, which appears after it has
been selected. This time corresponds to the time required for the
maximum wash load for each type of programme. If an option is
selected/deselected, the time is automatically updated. After the
programme has started, the time decreases (and is updated) minute
by minute.
 - End of the programme is indicated by a permanently lit zero
(when the door can be opened).
 - Appliance stopped with water in the tub, after programmes with
the RINSE HOLD option. This is displayed by a permanently lit zero.
The LED indicating the door remains on and the LED on the
START/PAUSE button is turned off. The washing machine continues
to operate, rotating the drum once every 2 minutes.
 - Delayed start, selected on the related button. After the
START/PAUSE button is pressed, the countdown starts and the delay
time decreases hour by hour, from a delay of 2 hours up to 20 hours
( 30' 60' 90' 2h 3h... 20hrs. 0hrs.).

During the last 2 hours, it decreases by 30 mins at a time.
During delayed start, the icon
 - Padlock: when lit, it indicates that all the buttons are disabled to
prevent children from altering, starting or pausing the cycle;
To disable this function, a key combination needs to be pressed,
which can be printed on the control panel or described in the
instruction manual.
 - Wrong choice of an option: displayed by the message "Err", when
a function that is not compatible with the chosen programme is
selected. the display duration is two seconds.

Alarm code indicates an error in the appliance operation; the
START/PAUSE button flashes when the code is displayed.
Technical Support - DMM
   
60' 90' 2h
remains permanently lit.
47/124
 
3h... 20h 0h)
599 75 58-67 Rev.04