Sensor - Leds And Display - Electrolux EWM09311 Service Manual

4.2.3.3 Sensor – LEDs and Display
The function of each touch sensor is defined via the configuration of the appliance (the data and images are for
guidance only).
The touch sensors are positioned under the silk-screen printed symbols on the control panel (circled here in red).
A light touch on the centre of the symbol is enough to activate/deactivate the function linked to the sensor with
the switching on/off of the relative Led confirming that the enabling/disabling has taken place.
At the same time as the enabling/disabling, the cycle duration time is updated via the digits.
You need to keep your finger pressed down for a longer period of time with the Start/Pause sensor to confirm
both the cycle's start and pause, in order to avoid unwanted starts or accidental pauses.
Every time you touch a sensor, you need to lift your finger up by a centimetre and half a second needs to
elapse before touching it again, otherwise the electronic system does not recognise that the sensor has been
touched for a second time.
The sensors used for adjusting the: temperature, spin and delayed start have a continued variation of values
as long as your finger is in contact with the sensor.
• Sensor no. 2: TEMPERATURE (configurable)
The temperature is always associated with the first sensor, in
combination with the six LEDs located in the top left hand corner
of the display.
The initial temperature displayed is that set for the chosen
programme.
By touching the sensor you can lower the temperature. Once this
has been reached the selection starts again from the highest
available one for the selected programme.
The selected temperature is shown by turning on the LEDs near
the silk-screen printed value on the control panel.
The temperatures available (displayed in °C) are: 90°C, 60°C, 40°C, 30°C, 20°C cold cycle.
The cold cycle is indicated by the symbol
The initial temperature set for each programme is configurable.
The temperature of 50°C is not envisaged.
Technical Support - DMM
.
11/124
599 75 58-67 Rev.04