Table of Contents
Advertisement
10.3 Rapid reading of alarms
It is possible to display the last alarm even if the selector is not in the eleventh diagnostics position or if the
appliance is in normal operating mode (for example when performing a wash programme):
→ 10 seconds after turning on the appliance, simultaneously touch the START/PAUSE sensor and the
nearest sensor option (as if accessing DIAGNOSTICS) for at least 2 seconds:
In the TC4/TC3 aesthetics, the display shows the last alarm.
In the TC5 aesthetics, the LEDs initially switch off, and then display the flashing sequence indicating the
last alarm.
→ The alarm continues to be displayed for the required time and then returns to its normal function or until
a sensor is touched.
→ The alarm reading system is as described in para. 9.2.
→ While the alarm is being displayed, the appliance continues to perform the cycle or, if in the programme
selection phase, it stores the previously selected
10.4 Deleting the last alarm
It is good practice to cancel the alarms stored:
•
after reading the alarm codes, to check whether the alarm re-occurs during the diagnostic cycle
•
after repairing the appliance, to check whether it re-occurs during testing
N.B. With this operation all the alarms stored are deleted.
TC 5
1. Enter the diagnostic mode (para. 9.1 or para. 9.2).
2. Turn the selector clockwise until the eleventh LED lights up.
3. Simultaneously press the START/PAUSE sensor and the nearest option sensor (as shown
in the diagram).
4. Keep your fingers over the sensors until the LCD display shows "E00" (at least 5 seconds).
Technical Support - DMM
options.
TC 4
41/124
TC 3
599 75 58-67 Rev.04
Advertisement
Table of Contents
