Dell Command Line Interface User Manual page 23

Table 3-1. omreport Command Level 1, Level 2, and Level 3 (continued)
Command Command
level 1 level 2
storage
system
Command User
level 3 privilege
required
frontpanel U, P , A
fru U, P , A
info U, P , A
intrusion U, P , A
leds U, P , A
memory U, P , A
nics U, P , A
ports U, P , A
processors U, P , A
pwrsupplies U, P , A
remoteaccess U, P , A
slots U, P , A
temps U, P , A
volts U, P , A
U, P , A
U, P , A
omreport: Viewing System Status Using the Instrumentation Service
Use
Shows whether the front panel button settings,
such as for the Power button and/or Nonmasking
Interrupt (NMI) button (if present on the
system), are enabled or disabled.
Shows the Field Replaceable Unit (FRU)
information.
Shows a status summary for main system chassis
components.
Shows the status of the system's intrusion
sensor(s).
Shows the properties you have set for LEDs to
flash under various alert conditions.
Shows properties of your system's memory arrays.
Shows number of NICs installed in your system,
NIC vendor, NIC description, IP address, and
connection status.
Shows properties for your system's parallel and
serial ports, such as I/O address, IRQ level,
connector type, and maximum speed.
Shows properties of your system's processors,
including speed, manufacturer, and
processor family.
Shows properties of power supplies.
Shows general information on remote access.
Shows properties of your system's expansion slots
and other slot types.
Shows the status and thresholds for the system
temperature sensors.
Shows the status and thresholds for the system
voltage sensors.
See "Using the Storage Management Service."
Shows a high-level summary of system
components.
23