Omreport Chassis Volts; Omreport System Commands; Omreport System; Commands For Viewing Logs - Dell Command Line Interface User Manual

omreport chassis volts

Use the omreport chassis volts command to view properties of your system's voltage probes.
When you type:
omreport chassis volts index= n
The index parameter is optional. If you do not specify the index, Server Administrator displays a summary
of status, readings, and thresholds set for any voltage probes that might be present on your system. If you
specify the index, Server Administrator displays a summary for a specific voltage probe.

omreport system Commands

Use the omreport system commands to view logs, to see how shutdown actions are configured, and to
view threshold values, cost of ownership information, and information about how recovery actions
are configured.

omreport system

Use the omreport system command to see a general status for your system components. When you
specify a level 3 command, such as omreport system shutdown, you can get detailed information for one
system component rather than the high level status that you get with omreport system.
Type:
omreport system
If your system has both a main system chassis and at least one direct attached storage device,
Server Administrator may display a summary that resembles the following example.
NOTE:
As with all output shown in this guide, the following output is an example and may vary depending on your
system configuration.
SEVERITY : COMPONENT
Ok : Main System Chassis
Critical : Storage

Commands for Viewing Logs

You can use the omreport system command to view logs: the alert log, the command log, and the
hardware or ESM log.
NOTE:
If the Alert log or Command log displays invalid XML data (such as when XML data generated for the
selection is not well-formed), clearing the log by typing "omconfig system alertlog action=clear" or "omconfig
system cmdlog action=clear" resolves the issue. If you need to retain the log information for future reference, you
should save a copy of the log before clearing the log. See "Commands for Clearing Logs" for more information about
clearing logs.
omreport: Viewing System Status Using the Instrumentation Service
39