Table 3-2. BIOS Setup Parameters (continued)
Parameters
RAID Channel A
RAID Channel B
SATA
SATA port
Secondary SCSI
Serial Communications
Serial Port 1
Serial Port 2
Speaker
USB or USBB
User accessible USB
omreport chassis bmc
NOTE:
This command will be phased-out in future releases. It will be replaced by the command omreport chassis
remoteaccess.
Use the omreport chassis bmc command to view baseboard management controller (BMC)
general information.
Type:
omreport chassis bmc
The output from the omreport chassis bmc command lists each of the valid parameters. Table 3-3 shows
the available settings.
Description
Displays whether RAID-on-motherboard Channel A is detected as a
RAID device or a SCSI device.
Displays whether RAID-on-motherboard Channel B is detected as a
RAID device or a SCSI device.
Displays whether the onboard SATA controller is set to ATA mode,
RAID mode, or is disabled.
Displays if the SATA port is enabled or disabled.
Displays whether the device is enabled or disabled.
Displays whether COM port 1 and COM port 2 are enabled or
disabled with or without console redirection.
Displays whether serial port 1 is mapped to a COM port, a
COM port 1, a COM port 3, a COM1 BMC, a BMC Serial, a BMC
NIC, a BMC RAC, or is disabled.
Displays whether serial port 2 is mapped to a COM port, a
COM port 2, a COM port 4, or is disabled.
Displays whether the speaker is on or off.
Displays whether the USB port is enabled or disabled.
Displays whether the user-accessible USB port is enabled or disabled.
omreport: Viewing System Status Using the Instrumentation Service
29