Dell Command Line Interface User Manual page 57

Table 4-2. BIOS Setup (continued)
name=value pair 1
attribute=
attribute=crab
attribute=cpuht
attribute=cpuvt
attribute=dbs
attribute=diskette
attribute=dualnic
attribute=extserial
attribute=fbr
name=value pair 2
setting=
setting=enable | disable
setting=enable | disable
setting=enable | disable
setting=enable | disable
setting=off | auto | writeprotect
setting=off | onpxeboth |
onpxenone | onpxenic1 |
onpxenic2
setting=com1 | com2 | rad
setting=9600 | 19200 | 57600 |
115200
omconfig: Managing Components Using the Instrumentation Service
Description
enable: Enable BIOS console redirection after
system reboot.
disable: Disable BIOS console redirection.
NOTE:
The command crab is valid for Dell
PowerEdge x9xx systems only.
enable: Enable logical processor hyper threading.
disable: Disable logical processor hyper threading.
enable: Enable virtualization.
disable: Disable virtualization.
enable: Enables Demand Based Power
Management (DBS) on the system.
disable: Disables DBS on the system.
off: Disable the diskette drive.
auto: Auto enable the diskette drive.
writeprotect : Do not allow writes. Make the
diskette drive read only.
off: The NICs are disabled.
onpxeboth: Both the NICs are PXE enabled.
onpxenone: PXE is not enabled on either of the
NICs.
onpxenic1: PXE is enabled on NIC 1.
onpxenic2: PXE is enabled on NIC 2.
com1: Maps external serial connector to COM 1.
com2: Maps external serial connector to COM 2.
rad: Maps external serial connector to remote
access device.
9600: Sets the console redirection failsafe baud rate
to 9600 bits per second.
19200: Sets the console redirection failsafe baud rate
to 19200 bits per second.
57600: Sets the console redirection failsafe baud
rate to 57600 bits per second.
115200: Sets the console redirection failsafe baud
rate to 115200 bits per second.
57