Dell Command Line Interface User Manual page 28

Table 3-2. BIOS Setup Parameters
Parameters
Bezel
Bootsequence
Console Redirection
Console Redirection After Boot
Diskette
Demand Based Power
Management (DBS)
Dual NIC
External Serial Connector
Console Redirection Failsafe Baud
Rate
IDE
IDE Primary Drive 0
IDE Primary Drive 1
Intrusion
Mouse
NIC 1
NIC 2
Numlock
Parallel port address
Parallel port mode
Primary SCSI
RAID on motherboard
28
omreport: Viewing System Status Using the Instrumentation Service
Description
Displays whether the bezel removal intrusion check during system
reboot is enabled or disabled.
Displays the device that is used to boot the system.
Displays if the BIOS screen is redirected over a particular serial port
or if it is turned off.
Displays whether console redirection after system reboot is enabled
or disabled.
Displays whether the diskette is disabled, auto enabled, or read only.
Displays whether DBS is enabled or disabled on the system.
Displays whether NIC 1 and NIC 2 with PXE is enabled or disabled.
Displays whether the external serial connector is mapped to COM
port 1 or COM port 2 or a Remote Access Device.
Displays the setting for console redirection failsafe baud rate.
Displays whether the drive is enabled or disabled.
Displays whether the device is automatically detected and enabled
or if the device is disabled.
Displays whether the device is automatically detected and enabled
or if the device is disabled.
Displays whether the intrusion check is enabled or disabled during
system boot.
Displays whether the mouse is enabled or disabled.
Displays whether the first NIC is enabled (with or without PXE) or
disabled during system boot.
Displays whether the second NIC is enabled (with or without PXE)
or disabled during system boot.
Displays whether the keypad can be used as number keys.
Displays whether the address is located on LPT1, LPT2, and LPT3,
or if it is disabled.
Displays the setting associated with the parallel port.
Displays whether the device is on or off.
Displays whether RAID-on-motherboard is detected as a RAID
device, a SCSI device, or if the device is disabled during system boot.