Scanner; Overview - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 7 Replacing the Consumables
7
Attach the shaft.
1 Insert the right end of the shaft into the slot, and lower the other
end gradually.
2 Rotate the bushing to lock the shaft.
3 Close the sheet guide. Make sure that both ends of the sheet
guide are locked firmly.
Confirm that the pick roller is installed properly.
Otherwise, it may cause feeding errors such as paper
jams.
Shaft
Bushing
Shaft
8
Close the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page
Be careful not to have your fingers caught
when the ADF closes.
9
Attach the ADF paper chute.
Insert the tabs into the slots on the back of the scanner, and tilt the
ADF paper chute backwards until it locks in place.
Side guide
Tab
1
10
Reset the consumable counter.
Start up the Software Operation Panel and reset the counter.
For details, refer to "Resetting the counters" (page
24).

Scanner

Overview

How to Load
Documents
Configuring the
Scan Settings
ADF paper chute
How to Use the
Operator Panel
Various Ways to
Scan
2
Daily Care
Replacing the
Consumables
167).
Troubleshooting
Operational
Settings
TOP
Contents
Index
Introduction
Appendix
Glossary
123