Overview; Introduction; Scanner; Documents - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 2 How to Load Documents
When you scan plastic cards, take note of the following.
- Up to three plastic cards can be loaded in the ADF paper
chute.
Note that you can only load one card at a time if the
plastic card is embossed.
- It is recommended to place the card face-down in the
ADF paper chute.
- Cards should be within the following specifications:
ISO7810 ID-1 type compliant
Size : 85.6 × 53.98 mm
Thickness : 1.4 mm or less (*1)
Material : PVC (polyvinyl chloride) or PVCA (polyvinyl
chloride acetate)
Make sure to check if the card can be scanned first.
*1: Up to 1.25 mm is supported for scanning at 200 dpi (60
ppm) in landscape when using fi-6140Z/fi-6240Z. This
setting can be changed in the Software Operation Panel
to scan plastic cards with a thickness up to 1.4 mm. For
details, refer to " Scanning Thick Plastic Cards [Feed
Mode] (fi-6140Z/fi-6240Z)" (page
- Rigid cards may not be fed properly.
- If the surface of the card is dirty with grease marks (e.g.
fingerprints) and such, perform scanning after wiping the
dirt off.
179).
- Plastic cards cannot be scanned when the imprinter is
connected.
- Scanning thick documents such as plastic cards will be
falsely detected as multifeed. In that case, disable
multifeed detection.
When scanning semi-transparent documents, increase the
brightness for scanning to avoid bleed-through.
When you scan documents written in lead pencil, make
sure to clean the rollers frequently. Otherwise, the rollers
will be contaminated which may leave black traces on the
document or cause feeding errors.
For details about cleaning, refer to "Chapter 6 Daily Care"
(page 108).
If multifeeds, pick errors or paper jams occur frequently,
refer to "8.3 Troubleshooting" (page
When you scan documents with the ADF, all documents
must be flat on the leading edge. Make sure that curls on
the leading edge of the documents are kept within the
following range.
30 mm or more
(1.18 in.)
Feeding direction
3 mm
5 mm
or less
or less
(0.12 in.)
(0.20 in.)
Leading edge Leading edge
Scanned side
Contents
Index

Introduction

Scanner

Overview

How to Load

Documents

Configuring the

Scan Settings

130).
How to Use the

Operator Panel

Various Ways to

30 mm or more
Scan
(1.18 in.)
Feeding direction
Daily Care
Scanned side
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
43